Cwlongshot

Short introduction into a die that I've used for many years. Its not new, it's really tailored to the cast bullet and it helps immensely with proper an squarely seating of your bullets. It stops shaving sides of bullets too.

RUMBLE EXCLUSIVE!! I removed the gas check shank. This time using just a 29/32 drill bit. Definitely not as smooth as the mill. But will work fine. Also powder coat thickness issue was entirely ME! There was a few HOT bullets! When your bullets are too hot they will attract powder like a magnet and NEVER SIFT OFF!!! So even temps on bullets. This was NOT from warming they where too hot from casting.

WOW WOW WOW. COAT's and looks incredible. I did need to lightly lube these bullets to run thru the sizer. They offered the most resistance I have ever experienced. But once a light lube sized 100% normally.

Remove the gas chip shake of this mold on four of the six cavities and this will be the first casting with that mold

ADE Optics plate Vortex Venom LwT Custom Ruger 10/22

RUMBLE EXCLUSIVE!! Casting a great MO slick side mold!! Drops fat HP (155g, narrow HP 165g, and Penta HP 160g & Solids 175g!

RUMBLE EXCLUSIVE VIDEO!!! I am Starting this project. 1)Weatherby Vanguard VGL action. 2) HS Precision stock 3) Leupold DD base and Rings 4) Redfield Base. 5) Barrel to be determined. But 6MM Rem chamber, probably 25" and med contour. Im leaning to a Stainless bbl as well. Throated, to allow long seated bullets to take advantage if the long action. Also a 1:8 twist. 6) The action is already pillar and aluminum bedding block bedded in the stock.

RUMBLE EXCLUSIVE!! The Powder Coat Store ARMY GREEN. Coats pretty well. Just a little thin. Remember this is a matte color.

This is a the powder coat store's, color traffic blue. Love the color but its gonna be a spray gun ol y color.

First Coyote hunt of 2022

MP 358-165 rf. It has 3 sets of HP pins. Thin deep, fat deep & Penta (kinda in-between) then flat point "pins". Beautifully made Brass 4 cavity.

One of my favorites. Made by a friends father who has passed. Its a Dandy 44spl Bullet.

I made a "oops". I seated .360 bullets i to Legend cases. My Bolt wont chamber even a .357 dia bullet... SO....

Rumble exclusive

2022 Video!!

These are two favorites. You can mill the top of your mold. But this will loose you weight. Or you can "ream" (carefully W/drill bit) of proper size.